Manual contents
← Manual

MANUAL / 03

Chains & PATH A / B

Arrange blocks, parallel branches and outputs.

All instructional screenshots in this manual show iPad. · NAM FX 1.x

Add and arrange effects

Choose an effect in MODULES and drag it into the chain. The signal flows through the blocks in order. Try Gate → Compressor → Drive → NAM → IR Loader → Delay → Reverb as a starting point, then drag blocks to audition a different order.

NAM FX on iPad — Add and arrange effects
iPad · MODULES · add effects

Find it on screen

  1. Expand a category in MODULES and drag the effect into the chain.
More iPad screens →

Parallel branches and merge

Create a split at a chain connection to feed two parallel lanes. Each lane can contain different effects. At the merge, use balance to adjust the relative lane levels and pan to position them in the stereo field. If frequencies cancel when you blend the lanes, check the sound in mono as well.

NAM FX on iPad — Parallel branches and merge
iPad · Parallel split · balance and pan

Find it on screen

  1. The orange connections mark the selected parallel split. Add another effect in the dashed slot below.
  2. Use BALANCE, A PAN and B PAN in the ROUTING panel to adjust the blend and stereo placement.
More iPad screens →

Choose the output

Select output connectors in each Path’s Output controls. Available channels come from the connected device. The looper, drums and click use OUT 1/2. Check the interface’s own settings to see which USB output pair feeds its headphone socket.

NAM FX on iPad — Choose the output
iPad · Output · mode and channels

Find it on screen

  1. Select OUT at the end of the chain to open that Path’s OUTPUT panel.
  2. Choose the mode under OUTPUT MODE and the physical channels under OUTPUT. This example uses OUT 1+2.
  3. Adjust LEVEL, MUTE, SOLO and the DRY / WET controls for your output setup.
More iPad screens →